The current rate numbers C1 to C5 are displayed by operating the channel of the transmitter. Like the flight condition function of the transmitter, you can set up to 5 different data for the attitude holding force rate of the aircraft in AVCS mode by operating the switch from the transmitter, and switch between them.

Hello guys I have been trying to set up flaps on my plane for at few days now, but i can't figure it out. I have the following configuration : Transmitter : Futaba T10J Receiver : R3008SB/FHSS (mode 1 / eight channel configuration) Plane :Multiplex Fun Cup 1 Servo for Elevator 1 Servo for Rudder 1 Servo for Tow release 2 servos for Alirons 2

Install the assembled steering wheel unit and APA to the transmitter using the screw (3.0x12mm cap screw) supplied. Page 25 Using a 2.5mm hex wrench, remove the mounting screws (3.0x1.2mm cap) of the opposite side charge unit. Remove the 2 mounting screws completely from the transmitter body.

User Manual-Rev.02 (160525) R. 1M23N3150 7. 2. Thank you for purchasing a Futaba T -FHSS 3 PV 2. 4 GHz system. This system is based on the. combination of the newly developed 2.4GHz transmitter and its corresponding receiver. Before using. your 3PV 2.4GHz system, read this manual carefully and use your R/C set safely.

Step 1) The Remote on/off is assumed to be on the Gear switch on channel 5. If channel. 6 is needed, set the throws as channel 6 below. Also, to use channel 6 instead of channel. 5, change the MASter channel to 6 in program modes 1 & 2. Here are the details for step 1. a) Press and hold MODE to enter setup. b) Roll the knob down to END POINT.
This is how I setup my flight condition on my Spektrum and Futaba Transmitter for the Omphobby M1 and M2. There are other videos that show you to setup chann eCly. 427 192 85 405 206 61 177 364 202

how to set up futaba transmitter